Forget scratched panels! This set includes tools for the 4 most common nuts in Eurorack!
1) Thonkiconn / Knobbicon 8mm knurled nut
2) Thonkiconn / Knobbicon 8mm hex nut
3) Befaco Bananuts / Cliff FC681374V / PJ3410 split nut
4) Doepfer (Cliff CL1384) hex nuts
A simple, small and affordable multi tool with all the neccesary modes you need when starting DIY. Later you can upgrade, but with this thing you can check your built for shorts, correct polarity and measure some voltages and resistances. Maybe most importantly it has a "beep" mode to check connections, traces, short circuits and so on.
DC Voltage: 200mV ~ 600V
AC Voltage: 200mV ~ 600V
DC Current: 200uA ~ 200mA
AC Current: 200uA ~ 200mA
Resistance: 200Ω ~ 20MΩ
Power: 3V CR2032 (NOT INCLUDED)
Size: 120 x 55 x 10mm
Kristall 611 is the best solder we could currently find, so we would like to offer it to you for your DIY projects. We tested dozens of solder wires and this stood out, even on difficult surfaces. The diameter of 0,7mm makes it kind of universal. What Stannol say in their own words: The Soldering Wire Kristall 611 electronics soldering wire is based on a halogen-activated "No-Clean" flux. It has been developed for high requirements for conventional soldering and for soldering SMDs in industrial production and for repair and resoldering. The wire flux Kristall 611 is a well activated flux based on synthetic resins. it combines high activity and good flow characteristics in an outstanding way with small amounts of solid and electrically safe residues.
Here you'll find the data-sheet and savety instructions.
• Very low flux spitting
• Leaves just slightly coloured residues
• Fast soldering
• No-Clean residues
• Chemically modified resin, reducing the health risks of using rosin based fluxes
• Mild odour
Vetus ST series tweezers are made of specially alloyed 302 stainless steel. The tweezers are of course anti-magnetic, non-glare and acid resistant. The Vetus-typical precision-manufactured tips together with a smooth action and a perfect balance make these tweezers an outstanding working tool.
Vetus ESD are special tweezers for medium SMD components, made of stainless steel, 100% anti-magnetic, acid-resistant, non-allergenic and non-glare. Ideally suited for holding cubic components. Tweezer handle covered with ESD safe plastic. The tweezers are suitable for soldering with hot air (in direct air flow).
Vetus SA series tweezers are stainless steel high precision tweezers, made of specially alloyed 302 stainless steel. The tweezers are of course anti-magnetic and glare-free. The Vetus-typical precision-manufactured tips together with a smooth action and a perfect balance make these tweezers an outstanding working tool.
Foldable magnifying glass, lens diameter 26mm, 30x magnification. Essential when you solder SMT parts and also handy to control your soldering joints.
Bit insert 1/4" Torx (TX25) from high grade tool-steel, length 25mm or length 50mm. These fit for our self-carving M5 screws with TX drive.
Desoldering braid (also known as desolder wick) with flux in dispenser. 2m, 2mm wide. In some cases you cannot use a desolder pump, then this stuff here is the way
to go. Very handy for example to clean holes on a PCB.
Connect yourself: Look for us on Facebook, Twitter, & Instagram!
Exploding Shed - DIY kits, modules & parts
Based in Leipzig, Germany
Shipping to Germany & EU, no USA
www.exploding-shed.com | firstname.lastname@example.org